Uni-Flexx front parts for XL 150
More flexibility in concrete construction
Uni-Flexx front parts for XL 150
Retrofitting in ceiling slabs
Correct planning is crucial in concrete construction, because concrete is unforgiving of mistakes – until now. With the Uni-Flexx, you can also retrofit spotlights, loudspeakers or other built-in devices into the already cast filigree ceiling. The required core drill hole is much smaller and therefore significantly cheaper than usual. This increases your flexibility on the construction site and saves you a lot of time and money. See for yourself.
The clever trick in concrete construction in action!
The trio for every construction site!
Thanks to the clever design, the Uni-Flexx only requires a small core drilling to retrofit spots or other built-in devices in ceiling slabs. A drill hole of 74 mm is sufficient to make the installation opening. This can be done by any fitter, for example with the Primo Schnellläufer. After the front part has been fixed, the installation housing XL 150 is attached. You now benefit from all advantages that the XL-Series offers. Among other things, conduit entry without tools, absolute concrete-tightness, integrated conduit grip and optimal thermal management.
Downloads:
PRIMO UNI-FLEXX
Your advantages in precast factories
Easy assembly
in just a few steps
1
Drill a 74 mm hole in the ceiling slab. The commercially available Primo High-Speed Driller is suitable for this.
2
If necessary, cut off installation segments to adapt the installation depth to the ceiling thickness.
3
Insert the Uni-Flexx into the drill hole.
4
Drill holes through the mounting brackets…
5
…and attach the Uni-Flexx front part to the ceiling with knock-in anchors.
6
Install XL 150 installation housing. The Universal Tunnel can optionally be attached to expand the installation space.
7
Open the membrane with a cutter knife to insert cables and conduits. The system is immediately absolutely concrete-tight and ensures reliable strain relief.
8
Attach the reinforcement and concrete the ceiling.
9
Connect built-in lights and other built-in devices from below and insert them into the 68 mm installation opening.
10
Suitable for clips with rubber coating and metal clips with expanding tabs.
11
Complete installation.
12
Done!
Component parts for the Uni-Flexx
YOU MIGHT ALSO BE INTERESTED IN:
Further solutions for precast factories
Do you have any questions about our products? We are there for You